Trigger:timer<N>:Start:overrun; Trigger:timer<N>:Start:seconds - Keithley 2461 Reference Manual

Section 6: SCPI command reference
:TRIGger:TIMer<n>:STARt:OVERrun?
This command indicates if an event was ignored because of the event detector state.
Type
Query only
Usage
:TRIGger:TIMer<n>:STARt:OVERrun?
<n>
Details
This command indicates if an event was ignored because the event detector was already in the
detected state when the event occurred.
This is an indication of the state of the event detector built into the timer itself. It does not indicate if
an overrun occurred in any other part of the trigger model or in any other construct that is monitoring
the delay completion event. It also is not an indication of a delay overrun.
This returns 0 if there is no overrun or 1 if there is an overrun.
Example
TRIG:TIM1:STAR:OVER?
Also see
None
:TRIGger:TIMer<n>:STARt:SEConds
This command configures an alarm or a time in the future when the timer will start.
Type
Command and query
Usage
:TRIGger:TIMer<n>:STARt:SEConds <time>
:TRIGger:TIMer<n>:STARt:SEConds?
<n>
<time>
6-240
Model 2461 Interactive SourceMeter® Instrument Reference Manual
Affected by
Not applicable
Trigger timer number (1 to 4)
Affected by
Recall settings
Instrument reset
Power cycle
Trigger timer number (1 to 4)
The time: 0 to 2,147,483,647 s
Where saved
Not applicable
Checks the overrun status on trigger timer 1.
Where saved
Save settings
Default value
Not applicable
Default value
0
2461-901-01 A/November 2015