Smu.measure.limit[Y].Autoclear - Keithley 2461 Reference Manual

Model 2461 Interactive SourceMeter® Instrument Reference Manual

smu.measure.limit[Y].autoclear

This attribute indicates if the test result for limit Y should be cleared automatically or not.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
value = smu.measure.limit[Y].autoclear
smu.measure.limit[Y].autoclear = value
value
Y
Details
When auto clear is set to on for a measure function, limit conditions are cleared automatically after
each measurement. If you are making a series of measurements, the instrument shows the limit test
result of the last measurement for the pass or fail indication for the limit.
If you want to know if any of a series of measurements failed the limit, set the auto clear setting to off.
When this set to off, a failed indication is not cleared automatically. It remains set until it is cleared
with the clear command.
The auto clear setting affects both the high and low limits.
Example
smu.measure.func = smu.FUNC_DC_CURRENT
smu.measure.limit[1].autoclear = smu.ON
Also see
smu.measure.limit[Y].clear()
2461-901-01 A/November 2015
Affected by
Restore configuration
Instrument reset
Power cycle
Measure configuration list
Function change
The auto clear setting:
Disable: smu.OFF
•
Enable: smu.ON
•
Limit number: 1 or 2
(on page 8-154)
Section 8: TSP command reference
Where saved
Configuration script
Measure configuration list
Turns on autoclear for limit 1 when
measuring DC current.
Default value
smu.ON
8-153