Keithley 2461 Reference Manual page 598

Model 2461 Interactive SourceMeter® Instrument Reference Manual
Details
This attribute specifies which event causes a LAN trigger packet to be sent for this trigger. Set the
event to one of the existing trigger events, which are shown in the following table.
Setting this attribute to none disables automatic trigger generation.
If any events are detected before the trigger LAN connection is sent, the event is ignored and the
action overrun is set.
Trigger events
Event description
No trigger event
Front-panel TRIGGER key press
Notify trigger block <n> (1 to 8); the trigger model generates a
trigger event when it executes the notify block
A command interface trigger:
Any remote interface: *TRG
•
GPIB only: GET bus command
•
VXI-11: VXI-11 command device_trigger
•
Line edge (either rising, falling, or either based on the
configuration of the line) detected on digital input line <n> (1 to 6)
Line edge detected on TSP-Link synchronization line <n> (1 to 3)
Appropriate LXI trigger packet is received on LAN trigger object
<n> (1 to 8)
Trigger event blender <n> (1 or 2), which combines trigger events BLENder<n>
Trigger timer <n> (1 to 4) expired
Source limit condition occurs
Example
TRIG:LAN1:OUT:STIM TIM1
Also see
:TRIGger:LAN<n>:OUT:CONNect:STATe
2461-901-01 A/November 2015
Event constant
NONE
DISPlay
NOTify<n>
COMMand
DIGio<n>
TSPLink<n>
LAN<n>
TIMer<n>
SLIMit
Set the timer 1 trigger event as the source for the
LAN packet 1 trigger stimulus.
(on page 6-218)
Section 6: SCPI command reference
6-221