Keithley 2461 Reference Manual page 600

Model 2461 Interactive SourceMeter® Instrument Reference Manual
Example
*RST
:SOURce:CONF:LIST:CRE "SOURCE_LIST"
:SENS:CONF:LIST:CRE "MEASURE_LIST"
:SOUR:VOLT 1
:SOURce:CONF:LIST:STORE "SOURCE_LIST"
:SENS:CURR:RANG 1e-3
:SENSe:CONF:LIST:STOR "MEASURE_LIST"
:SOUR:VOLT 5
:SOURce:CONF:LIST:STORE "SOURCE_LIST"
:SENS:CURR:RANG 10e-3
:SENSe:CONF:LIST:STOR "MEASURE_LIST"
:SOUR:VOLT 10
:SOURce:CONF:LIST:STORE "SOURCE_LIST"
:SENS:CURR:RANG 100e-3
:SENSe:CONF:LIST:STOR "MEASURE_LIST"
:TRIG:LOAD "ConfigList", "MEASURE_LIST", "SOURCE_LIST"
INIT
Set up a source configuration list named SOURCE_LIST and a measurement configuration list named
MEASURE_LIST.
Create the source list with three indexes that set the source voltage levels to 1, 5, and 10.
Create the measure list with three indexes that set the measure current ranges to 1 mA, 10 mA, and
100 mA.
Load the configuration list trigger model, using these two configuration lists. Start the trigger model.
Also see
None
2461-901-01 A/November 2015
Section 6: SCPI command reference
6-223