JVL MAC050 User Manual page 52

2.8
2.8.9 Transferring and saving the filter
After setting the filter choices, the filter can be transferred to the motor.
The complete setup including the filter configuration can also be saved to and later re-
called from disc by using the Open and Save buttons in the toolbar.
2.8.10 Additional adjustment
Now the desired filter is set up in the motor and the performance can be tested. Further
improvement may be required and typically it may be necessary to experiment in order
to obtain an optimum result.
Please note that the LOAD parameter must still be used to adjust the inertia ratio be-
tween the motor and load. See also Adjusting the LOAD parameter, page 43.
48 JVL Industri Elektronik A/S - User Manual - Integrated Servo Motors MAC050 - 800
Servo filter adjustment