JVL MAC050 User Manual page 103

4.3 Expansion module MAC00-B41
Connected to a external controller
Position or
velocity
controller
±10V out
Ground
Connected to a potentiometer
Power supply
10VDC
2kOhm potentiometer
(JVL typeno. "POT2K")
This example only covers 0-10V but other configurations do of course also exist, such as 0-5V or +/-10V.
Connected to a zero search switch
Power supply
10-32VDC
Note: Do not apply voltages higher than 32V to the analogue input (AIN)
4.3.6 Using the analogue inputs (AIN1 or AIN2).
When a MAC00-B41 module is mounted in the MAC400 motor, the analogue inputs is
available in the same manner as in the basic motor itself.
The analogue inputs can be used for several applications and the function of the analogue
input is determined by the mode in which the motor is set to operate.
Typically the inputs is used for controlling the velocity, torque or position of the motor
but the input is also used as digital input for zero search or in "Air Cylinder Mode" where
it is used as trigger input for the movement done by the motor.
For further information concerning physical connections, see the Expansion MAC00-B41
connector description, page 105.
JVL Industri Elektronik A/S - User Manual - Integrated Servo Motors MAC050 - 800
Analogue input connection at the MAC motor
mounted with a MAC00-B41 module.
Screen
Note ! : screen only
connected to signal source.
If only 24V supply is available
insert a 2.7k resistor here.
Screen
Note ! : screen only
connected to signal source.
Zero search switch
MAC motor
Make sure that all
involved units are
+MAC00-B41
connected to the same
potential
AIN1
(analogue input)
GND
(ground)
MAC motor
Make sure that all
involved units are
+MAC00-B41
connected to the same
potential
AIN1
(analogue input)
GND
(ground)
MAC motor
Make sure that all
involved units are
+MAC00-B41
connected to the same
potential
AIN1
(analogue input)
GND
(ground)
Only MAC400&800
TT1138GB
99