JVL MAC050 User Manual page 102

4.3 Expansion module MAC00-B41
4.3.5 General power supply description
The MAC00-B41 module can only be used in the MAC400 motor. The diagram below
shows how to connect power to a MAC400 motor mounted with a MAC00-B41.
Please notice that the voltage connected to P+ and/or CVI must stay in the range +12-
32VDC. Precautions must therefore be taken if the system also contains MAC50, 95, 140
or 141 which may require 48VDC in order to reach maximum motor speed.
See also the general power supply description Power Supply, page 59.
98 JVL Industri Elektronik A/S - User Manual - Integrated Servo Motors MAC050 - 800
Power supply connections to a MAC140 and a MAC400
mounted with a MAC00-B1, B2 or B4 and B41 modules.
Make sure that all
involved units are
connected to the same
potential
MAC50-141 Motor
with MAC00-B1,
B2 or B4
Power
Supply
Control voltage
Only MAC50-141 with
B2 or B4 (Optional)
MAC400 Motor
with MAC00-B41
Power
Supply
Control Volt.
Main supply
Power supply
P+
P-
O+
P+
Max. 32VDC !
P-
CVI
Mains 115 or 230VAC
Only MAC400&800
It is recommended
that a separate supply
line is used for each motor.
TT1137GB