JVL MAC050 User Manual page 211

4.8 Expansion module MAC00-P5
4.8.5 General power supply description
The MAC00-P5 module can only be used in the MAC400 motor. The diagram below
shows how to connect power to a MAC400 motor mounted with a MAC00-P5.
Please notice that the voltage connected to CVI1 and P+(only -MAC00-P4) must stay in
the range +12-32VDC. Precautions must therefore be taken if the system also contains
MAC50, 95, 140 or 141 which may require 48VDC in order to reach maximum motor
speed.
See also the general power supply description Power Supply, page 59.
Typical power supply connection to a MAC140 and a MAC400
JVL Industri Elektronik A/S - User Manual - Integrated Servo Motors MAC050 - 800
mounted with a MAC00-B1, B2 or B4 and Px modules.
Make sure that all
involved units are
connected to the same
potential
MAC50-141 Motor
with MAC00-B1,
B2 or B4
Power
Supply
Control voltage
Only MAC50-141 with
B2 or B4 (Optional)
MAC400 Motor
with MAC00-Px
Power
Supply
Control Volt.
Main supply
Power supply
P+
P-
O+
P+
Max. 32VDC !
GND
CVI1
Mains 115 or 230VAC
Only MAC400&800
It is recommended
that a separate supply
line is used for each motor.
The terminal P+
do not exist on
MAC00-P5.
Use only CVI1
TT1168GB
207