JVL MAC050 User Manual page 171

4.5 Expansion Module MAC00-FD4
4.5.2 Node-id, Baud-rate and Termination setup
The 10-way dip switch (SW1) is used to select the node ID and the Baud-rate. Switches
1-6 select the node ID, and switches 8-9 select the Baud-rate. The 2-way dip switch
(SW2) is used to enable termination. When both switched are on, termination is enabled.
Dip 7 - Node-id set by software
JVL Industri Elektronik A/S - User Manual - Integrated Servo Motors MAC050 - 800
Dip 1-6 - Node-id setting
(address range 0-63)
Dip 8-9 - Baud rate
(Baud rate setting 125k to 500k)
Dip Switch 10 is not used.
Set in position "ON".
SW1 default settings =
all set in position "ON"
Dip 1-2 - Line termination
Both set to ON =
Term. enabled
Both set to OFF =
Term. disabled
Dip switch location on the
MAC00-FD4 Expansion module
M12 external
connectors
TT1017GB
MAC00-FD4 Dip switch settings
Rear side of the MAC00-FD4
Mini dip-switch
expansion module
OFF ON
1
2
3
4
5
6
7
8
9
0
SW1
1
2
SW2
SW2 default settings =
Both switches in position "OFF"
Basic MAC motor
housing
Internal circuit boards
Dip Switches placed
on the rear side of the
module
167