JVL MAC050 User Manual page 132

4.4 Expansion Modules MAC00-FC2/FC4
Press W on the keyboard, and the following screen appears:
7: Type 02 in the window, and press OK.
8: Click on the sub register 0x05, which is the register to choose which velocity the mo-
tor will run in. Press W on the keyboard, type 100 in the window, and press OK. 100
is in Counts/Sample.
9: Click on the sub register 0x03, which is the register to choose which distance the
motor shall run. Press on W on the keyboard, type 20000 in the window, and type
OK. 20000 is in Encoder Counts
Now shall the motor shaft rotate slowly, until the motor has counted 20000 Encoder
pulses. If you want to stop the motor, when click on sub register 0x02 and write 0 in the
window, and it will switch to passive mode. Now it is possible to change the value in the
register and change the speed and distance for the motor.
If using other software the test could be described as, (using object 2012h):
Sub-
register
02h
05h
03h
02h
02h
05h
03h
02h
128 JVL Industri Elektronik A/S - User Manual - Integrated Servo Motors MAC050 - 800
TT1076GB
Name Width
Mode_Reg 16 bit
V_SOLL 16 bit
P_SOLL 32 bit
Mode_Reg 16 bit
Returning the motor with higher velocity
Mode_Reg 16 bit
V_SOLL 16 bit
P_SOLL 32 bit
Mode_Reg 16 bit
Unit Operation
Set up the motor
in position mode
Counts/sample Sets up the desired velocity
The motor rotates the
Encoder count desired numbers of
encoder pulses
Sets the motor
to passive mode
Set up the motor
in position mode
Counts/sample Sets up the desired velocity
The motor rotates the
Encoder
desired numbers of
count
encoder pulses
Sets the motor
in passive mode
Value
02h
100h
20000
00h
02h
200h
-20000
00h