Example For Configuring Ssm Mapping - Huawei Quidway S9300 Configuration Manual - Multicast

2 IGMP Configuration
l

2.8.2 Example for Configuring SSM Mapping

Networking Requirements
On the multicast network as shown in
are used to provide multicast services. IGMPv3 is run on the interface on the S9300 connected
to the Receiver. The IGMP version on the Receiver is IGMPv2 and cannot be upgraded to
IGMPv3.
The range of SSM group addresses on the current network is 232.1.1.0/24. S1, S2, and S3 send
multicast data to the multicast group whose IP address is in this range. The Receiver receives
the multicast data only from S1 and S3.
2-24
interface vlanif 20
ip address 10.110.2.1 255.255.255.0
pim sm
igmp enable
#
interface vlanif 21
ip address 192.168.2.1 255.255.255.0
pim sm
#
interface gigabitethernet 1/0/0
port default vlan 20
#
interface gigabitethernet 2/0/0
port default vlan 21
#
ospf 1
area 0.0.0.0
network 10.110.2.0 0.0.0.255
network 192.168.2.0 0.0.0.255
#
return
Configuration file of S9300-C
#
sysname S9300-C
#
vlan batch 30 31
#
multicast routing-enable
#
interface vlanif 30
ip address 10.110.2.2 255.255.255.0
pim sm
igmp enable
#
interface vlanif 31
ip address 192.168.3.1 255.255.255.0
pim sm
#
interface gigabitethernet 1/0/0
port default vlan 30
#
interface gigabitethernet 2/0/0
port default vlan 31
#
ospf 1
area 0.0.0.0
network 10.110.2.0 0.0.0.255
network 192.168.3.0 0.0.0.255
#
return
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Figure 2-2, PIM-SM is run and ASM and SSM models
Configuration Guide - Multicast
Issue 01 (2009-07-28)