Configuring The S9300 Not To Receive Hello Messages Without The Generation Id - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
l
----End
3.6.3 Configuring the S9300 not to Receive Hello Messages Without
the Generation ID
Issue 01 (2009-07-28)
pim
The PIM view is displayed.
3. Run:
timer hello interval
The interval for sending Hello messages is set.
By default, Hello messages are sent every 30 seconds.
4. Run:
hello-option holdtime interval
The timeout interval of the reachable status of a neighbor is set. If not receiving any
Hello message in the period, the S9300 considers that the neighbor is unreachable.
By default, the timeout interval is 105 seconds.
Setting the PIM neighbor control parameters on an interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
On the S9300, VLANIF interfaces and loopback interfaces support PIM.
3. Run:
pim timer hello interval
The interval for sending Hello messages is set.
By default, Hello messages are sent every 30 seconds.
4. Run:
pim hello-option holdtime interval
The timeout interval of the reachable status of a neighbor is set. If not receiving any
Hello message in the period, the S9300 considers that the neighbor is unreachable.
By default, the timeout interval is 105 seconds.
5. Run:
pim triggered-hello-delay interval
The maximum delay for triggering Hello messages is set. This command helps to
prevent multiple S9300s from sending Hello messages at the same time.
By default, the maximum delay for triggering Hello messages is 5 seconds.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 PIM-DM Configuration
3-11