Changing The Values Of C-Rp Parameters - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Pre-configuration Tasks
Before setting the parameters for controlling a dynamic RP, complete the following tasks:
l
l
Data Preparation
To set the parameters for controlling a dynamic RP, you need the following data.
No.
1
2
3
4
5
6
7
8

4.8.2 Changing the Values of C-RP Parameters

Context
Do as follows on the S9300 where the C-RP is configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Issue 01 (2009-07-28)
Configuring the unicast routing protocol to ensure that IP routes between nodes are
reachable
4.4 Configuring Basic PIM-SM Functions
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 PIM-SM Configuration
Data
Priority of a C-RP
Interval at which a C-RP sends
Advertisement messages
Timeout period during which a BSR waits
Advertisement message from a C-RP
Hash mask length of a C-BSR
Priority of a C-BSR
Interval at which a C-BSR sends Bootstrap
messages
Holdtime of a Bootstrap message from the
BSR
ACL that defines the range of addresses of
valid BSRs.
4-23