Example For Connecting Rpf Routes Through Static Multicast Routes - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
<S9300-B> system-view
[S9300-B] ip rpf-route-static 8.1.1.0 255.255.255.0 13.1.1.2
Step 4 Verify the configuration.
# Run the display multicast rpf-info command on S9300-B to view the RPF information of the
source. The RPF information is as follows. The RPF routes and the RPF neighbor are updated
according to the static multicast route.
<S9300-B> display multicast rpf-info 8.1.1.2
VPN-Instance: public net
RPF information about source 8.1.1.2:
----End
Configuration Files
l
6.9.2 Example for Connecting RPF Routes Through Static Multicast
Routes
Issue 01 (2009-07-28)
RPF interface: vlanif40, RPF neighbor: 13.1.1.2
Referenced route/mask: 8.1.1.0/24
Referenced route type: mstatic
Route selection rule: preference-preferred
Load splitting rule: disable
Configuration file of S9300-B
#
sysname S9300-B
#
vlan batch 10 40 50
#
multicast routing-enable
#
interface vlanif 10
ip address 9.1.1.2 255.255.255.0
pim dm
#
interface vlanif 40
ip address 13.1.1.1 255.255.255.0
pim dm
#
interface vlanif 50
ip address 7.1.1.1 255.255.255.0
pim dm
igmp enable
#
interface GigabitEthernet1/0/0
port hybrid tagged vlan 10
#
interface GigabitEthernet2/0/0
port hybrid tagged vlan 40
#
interface GigabitEthernet3/0/0
port hybrid untagged vlan 50
#
ospf 1
area 0.0.0.0
network 7.1.1.0 0.0.0.255
network 9.1.1.0 0.0.0.255
network 13.1.1.0 0.0.0.255
#
ip rpf-route-static 8.1.1.0 255.255.255.0 13.1.1.2
#
return
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Multicast Route Management
6-19