Configuring The Multicast Forwarding Range; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
----End
Example
Run the display multicast routing-table command, and you can view the multicast routing
table.
<Quidway> display multicast routing-table
Multicast routing table of VPN-Instance: public net
Total 1 entry
00001. (172.168.0.2, 227.0.0.1)

6.6 Configuring the Multicast Forwarding Range

This section describes how to configure the multicast forwarding range.

6.6.1 Establishing the Configuration Task

6.6.2 Configuring the Multicast Forwarding Boundary
6.6.3 Checking the Configuration
6.6.1 Establishing the Configuration Task
Applicable Environment
On a network, the multicast information each for multicast group is transmitted in a certain range.
You can configure the multicast forwarding range on an S9300. You can configure a multicast
forwarding boundary on an interface to form a closed multicast forwarding area.
When an interface is configured with the forwarding boundary for a multicast group, the
S9300 cannot forward or receive any packet of the group.
Pre-configuration Tasks
Before configuring a multicast forwarding policy, complete the following tasks:
l
l
Data Preparation
To configure a multicast forwarding policy, you need the following data.
Issue 01 (2009-07-28)
interface { include | exclude | match } { interface-type interface-number | register |
none } ] command to check the information about the multicast routing table.
Uptime: 00:00:28
Upstream Interface: Vlanif100
List of 2 downstream interfaces
1: Vlanif101
2: Vlanif102
Configuring the unicast routing protocol to ensure that IP routes between nodes are
reachable
Configuring basic multicast functions
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Multicast Route Management
6-9