Configuring The Content Of An Sa Message - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Data Preparation
To set parameters of SA messages, you need the following data.
No.
1
2
3
4
5
6
7

5.7.2 Configuring the Content of an SA Message

Context
Do as follows on the source RP where an MSDP peer is configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
msdp
The MSDP view is displayed.
Step 3 Run:
encap-data-enable
The function of encapsulating a multicast packet in an SA message is enabled.
By default, an SA message contains only the (S, G) message without any multicast packet
encapsulated.
Step 4 (Optional) Run:
peer peer-address minimum-ttl ttl
The TTL threshold of multicast packets is set.
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Data
(Optional) TTL threshold for forwarding SA
messages that contain multicast packets
Address of the remote MSDP peer
(Optional) ACL for filtering received SA
request messages
Maximum number of (S, G) entities to be
cached
(Optional) ACL for filtering SA messages
(Optional) ACL for filtering received SA
messages
(Optional) ACL for filtering to-be-forwarded
SA messages
5 MSDP Configuration
5-19