Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Multicast

4 PIM-SM Configuration
----End

4.10.4 Checking the Configuration

Prerequisite
The setting of the forwarding control parameters is complete.
Procedure
l
l
l
----End
Example
Run the display pim interface vlanif 15 verbose command to check the PIM information on
VLANIF 15.
<Quidway> display pim interface vlanif 15 verbose
VPN-Instance: public net
Interface: Vlanif15, 10.0.0.15
4-36
By default, the interval for overriding the prune operation is 2500 milliseconds.
Run the display pim interface [ interface-type interface-number | up | down ]
[ verbose ] command to check the PIM information on the interface.
Run the display pim control-message counters [ interface interface-type interface-
number ] [ message-type message-type ] command to check the number of sent and
received PIM control messages.
Run the display pim routing-table [ group-address [ mask { group-mask-length | group-
mask } ] ] [ source-address [ mask { source-mask-length | source-mask } ] ] [ incoming-
interface { interface-type interface-number | register } ] [ outgoing-interface { include |
exclude | match } { interface-type interface-number | register | none } ] [ mode { dm |
sm | ssm } ] [ flags flag-value ] [ fsm ] command to check the PIM multicast routing table.
PIM version: 2
PIM mode: Sparse
PIM state: up
PIM DR: 10.0.0.15 (local)
PIM DR Priority (configured): 1
PIM neighbor count: 0
PIM hello interval: 30 s
PIM LAN delay (negotiated): 1800 ms
PIM LAN delay (configured): 1800 ms
PIM hello override interval (negotiated): 60000 ms
PIM hello override interval (configured): 60000 ms
PIM Silent: disabled
PIM neighbor tracking (negotiated): enabled
PIM neighbor tracking (configured): enabled
PIM generation ID: 0XE5F4034D
PIM require-GenID: disabled
PIM hello hold interval: 36000 s
PIM assert hold interval: 3600 s
PIM triggered hello delay: 5 s
PIM J/P interval: 60 s
PIM J/P hold interval: 210 s
PIM state-refresh capability on link: non-capable
PIM BSR domain border: enabled
PIM BFD: disabled
PIM dr-switch-delay timer : not configured
Number of routers on link not using DR priority: 0
Number of routers on link not using LAN delay: 0
Number of routers on link not using neighbor tracking: 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Issue 01 (2009-07-28)