Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Multicast

Terabit routing switch
Hide thumbs Also See for Quidway S9300:
Table of Contents

Advertisement

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Context
After receiving a Leave message from a host, the querier reports the message to the upstream
router instead of sending a Last Member Query message. This process is called IGMP prompt
leave. In this manner, the delay in response is reduced and the bandwidth occupied by various
messages is saved.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The S9300 communicates with hosts through this interface. On the S9300, VLANIF interfaces
and loopback interfaces support IGMP.
Step 3 Run:
igmp prompt-leave [ group-policy basic-acl-number ]
The S9300 leaves the group immediately without sending the Last Member Query message.
By default, the S9300 sends the Last Member Query message after receiving a Leave message
from a host.
----End

2.5.6 Checking the Configuration

Prerequisite
The configuration of basic IGMP functions and parameters is complete.
Procedure
l
l
l
Issue 01 (2009-07-28)
NOTE
IGMP prompt leave is applicable only to IGMPv2.
l
When the IGMP version is IGMPv1 or IGMPv3, the IGMP prompt leave does not take effect even
l
if there is information about this function in current configuration.
Run the display igmp group [ group-address | interface interface-type interface-
number ] [ static | verbose ] command to check the information about members of an IGMP
multicast group.
Run the display igmp interface [ interface-type interface-number ] [ verbose ] command
to check the configuration and running status of IGMP on the interface.
Run the display igmp routing-table [ group-address [ mask { group-mask | group-mask-
length } ] | source-address [ mask { source-mask | source-mask-length } ] ]
command to check the information about the IGMP routing table.
Run the preceding command, and you can obtain the following result:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 IGMP Configuration
*
[ static ]
2-15

Advertisement

Table of Contents
loading

Table of Contents