Debugging Msdp; Configuration Examples; Example For Configuring Basic Msdp Functions - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
l
l
----End

5.8.4 Debugging MSDP

Context
Debugging affects the performance of the system. So, after debugging, run the undo debugging
all command to disable it immediately.
When an MSDP fault occurs, run the following debugging commands in the user view to locate
the fault.
Procedure
l
l
l
l
l
----End

5.9 Configuration Examples

This section provides several configuration examples of MSDP.

5.9.1 Example for Configuring Basic MSDP Functions

5.9.2 Example for Configuring Inter-AS Multicast by Using Static RPF Peers
5.9.3 Example for Configuring Anycast RP
5.9.1 Example for Configuring Basic MSDP Functions
Networking Requirements
As shown in
domains; each PIM-SM domain has 0 or 1 multicast source and receiver. The receivers in PIM-
SM2 need to receive the multicast data sent by S3 in the PIM-SM3 domain and multicast data
sent by S1 in the PIM-SM1 domain.
Issue 01 (2009-07-28)
Run the display msdp sa-cache [ group-address | source-address | as-number ]
to check the information about (S, G) entries in the SA cache.
Run the display msdp sa-count [ as-number ] command to view the number of (S, G)
entries of MSDP in the SA cache.
CAUTION
Run the debugging msdp all command to enable all the debugging of MSDP.
Run the debugging msdp connect command to enable debugging of TCP connection
resetting of the MSDP peer.
Run the debugging msdp event command to enable debugging of MSDP events.
Run the debugging msdp packet command to enable debugging of MSDP messages.
Run the debugging msdp all command to enable debugging of active MSDP sources.
Figure 5-1, two ASs exist on the network. Each AS contains one or more PIM-SM
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 MSDP Configuration
*
command
5-25