Huawei Quidway S9300 Configuration Manual - Multicast page 176

4 PIM-SM Configuration
Procedure
Step 1 Configure the IP address of each interface and the unicast routing protocol.
# Configure IP addresses and masks of interfaces on the S9300s according to
Configure OSPF between S9300s to ensure that the S9300s can communicate at the network
layer and update routes through the unicast routing protocol.
For how to configure IP addresses of interfaces, see
Interface
configure OSPF, see
Routing.
Step 2 Enable multicast on all S9300s and PIM-SM on all interfaces.
# Enable multicast on all the S9300s and enable PIM-SM on all interfaces. The configurations
of S9300-B, S9300-C, and S9300-D are similar to the configuration of S9300-A, and are not
mentioned here.
[S9300-A] multicast routing-enable
[S9300-A] interface vlanif 101
[S9300-A-Vlanif101] pim sm
[S9300-A-Vlanif101] quit
[S9300-A] interface vlanif 100
[S9300-A-Vlanif100] pim sm
[S9300-A-Vlanif100] quit
[S9300-A] interface vlanif 200
[S9300-A-Vlanif200] pim sm
[S9300-A-Vlanif200] quit
Step 3 Enable IGMP on the interfaces connected to hosts.
# Enable IGMP on the interface connecting S9300-A to hosts. The configurations of S9300-B,
S9300-C, and S9300-D are similar to configuration of S9300-A, and are not mentioned here.
[S9300-A] interface vlanif 101
[S9300-A-Vlanif101] igmp enable
[S9300-A-Vlanif101] igmp version 3
Step 4 Enable PIM silent on S9300-A.
[S9300-A] interface vlanif 101
[S9300-A-GVlanif101] pim silent
Step 5 Configure the RP.
This example shows how to configure the static RP and the dynamic RP and to specify the
dynamic RP as the preferred RP and the static RP as the standby RP.
# Configure the dynamic RP on one or more S9300s in the PIM-SM domain. In this example,
set the service range of the RP and specify the locations of the C-BSR and the C-RP on S9300-
E.
[S9300-E] acl number 2008
[S9300-E-acl-basic-2008] rule permit source 225.1.1.0 0.0.0.255
[S9300-E-acl-basic-2008] quit
[S9300-E] pim
[S9300-E-pim] c-bsr vlanif 100
[S9300-E-pim] c-rp vlanif 100 group-policy 2008 priority 0
4-56
in the Quidway S9300 Terabit Routing Switch - Basic Configuration. For how to
OSPF Configuration
NOTE
The RP can be configured in two modes: the static RP and the dynamic RP. The static RP can be configured
together with the dynamic RP. You can also configure only the static RP or the dynamic RP. When the
static RP and the dynamic RP are configured simultaneously, you can change the parameter values to
specify which RP is preferred.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Assigning an IP Address to an
in the Quidway S9300 Terabit Routing Switch - IP
Figure 4-2.
Issue 01 (2009-07-28)