Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Context
The S9300 that fails in the assert election prohibits downstream interfaces from forwarding
multicast data and keeps the Assert status for a period. After the period, the S9300 restores the
downstream interfaces to forward messages.
The Assert control parameters can be set globally or on an interface.
l
l
Procedure
l
l
----End

3.10.3 Checking the Configuration

Prerequisite
The setting of the Assert control parameters is complete.
Issue 01 (2009-07-28)
The global configuration is valid for each interface.
The configuration on an interface is valid only for the specified interface. The configuration
on an interface takes precedence over the global configuration. If the assertion holding time
is not set on the interface, the global configuration is used.
Setting the Assert control parameters globally
1. Run:
system-view
The system view is displayed.
2. Run:
pim
The PIM view is displayed.
3. Run:
holdtime assert interval
The period for keeping the Assert state is set.
By default, the timeout period for keeping the Assert state is 180 seconds.
Setting the Assert control parameters on an interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
On the S9300, VLANIF interfaces and loopback interfaces support PIM.
3. Run:
pim holdtime assert interval
The period for keeping the Assert state is set.
By default, the timeout period for keeping the Assert state is 180 seconds.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 PIM-DM Configuration
3-25