Enabling Msdp - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
To ensure that all RPs on the network can share the source information and the number of
S9300s configured with MSDP peers is minimized, it is recommended to configure the MSDP
peers on the RPs (including static RPs and C-RPs) only on the network.
To ensure that the transmission of SA messages between MSDP peers is not interrupted by the
RPF rule and redundant traffic is minimized, use the following configuration schemes:
l
l
Pre-configuration Tasks
Before configuring basic MSDP functions, complete the following tasks:
l
l
Data Preparation
To configure basic MSDP functions, you need the following data.
No.
1
2
3
4

5.4.2 Enabling MSDP

Context
Before enabling a function of MSDP, you must enable MSDP.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
Issue 01 (2009-07-28)
Add all MSDP peers that belong to the same AS to one mesh group.
Perform either of the following operations on the MSDP peers across ASs:
Create MBGP peers that use the same interface address.
–
Configure the MSDP peers as the static RPF peers of each other.
–
NOTE
BGP and MBGP can be used to establish the EBGP peer relation. MBGP is recommended because MBGP
does not affect the unicast topology on the network.
Configure the unicast routing protocol to make the IP routes of nodes be reachable.
Configure the PIM-SM domain and enable multicast in the domain.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Data
Address of the remote MSDP peer
Type and number of the interface connected
to the remote MSDP peer
Description of the MSDP peer
Name of the mesh group
5 MSDP Configuration
5-5