Checking The Configuration; Maintaining Multicast Routes - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Context
The setting takes effect only after you run the reset multicast forwarding-table command.
Running the reset multicast forwarding-table command interrupts multicast services.
Therefore, confirm the action before you run the command.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
multicast forwarding-table downstream-limit limit
The maximum number of downstream nodes of a single routing entity in the multicast forwarding
table is set.
By default, a route in the multicast forwarding table has a maximum of 128 downstream nodes.
----End

6.7.4 Checking the Configuration

Prerequisite
The setting of parameters for controlling the multicast forwarding table is complete.
Procedure
l
----End

6.8 Maintaining Multicast Routes

This section describes how to clear the statistics on multicast routing and forwarding, and debug
multicast routing and forwarding.
6.8.1 Checking the Multicast Routes
6.8.2 Checking the RPF Path and Multicast Path
6.8.3 Clearing Routing Entries and Multicast Forwarding Entities
Issue 01 (2009-07-28)
CAUTION
Run the display multicast forwarding-table [ group-address [ mask { group-mask |
group-mask-length } ] | source-address [ mask { source-mask | source-mask-length } ] |
incoming-interface { interface-type interface-number | register } | outgoing-interface
{ { include | exclude | match } { interface-type interface-number | register | none } } |
statistics | slot slot-number ]
forwarding table.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
command to check the information about the multicast
6 Multicast Route Management
6-13