Debugging Multicast Forwarding And Routing; Configuration Examples - Huawei Quidway S9300 Configuration Manual - Multicast

6 Multicast Route Management
Procedure
l
l
l
l
l
----End

6.8.5 Debugging Multicast Forwarding and Routing

Context
Debugging affects the performance of the system. So, after debugging, run the undo debugging
all command to disable it immediately.
When a multicast fault occurs, run the following debugging commands in the user view to locate
the fault.
Procedure
l
l
----End

6.9 Configuration Examples

This section provides several examples of static route configuration.
6-16
Run the display multicast boundary [ group-address [ mask | mask-length ] ]
[ interface vlanif vlan-id ] command to check the information about the multicast boundary
configured on the interface.
Run the display multicast forwarding-table [ group-address [ mask { group-mask |
group-mask-length } ] | source-address [ mask { source-mask | source-mask-length } ] |
incoming-interface { interface-type interface-number | register } | outgoing-interface
{ { include | exclude | match } { interface-type interface-number | register | none } } |
statistics | slotslot-number ]
forwarding table.
Run the display multicast routing-table [ group-address [ mask { group-mask | group-
mask-length } ] ] [ source-address [ mask { source-mask | source-mask-length } ] ]
[ incoming-interface { interface-type interface-number | register } ] [ outgoing-
interface { include | exclude | match } { interface-type interface-number | register |
none } ] command to check the information about the IP multicast routing table.
Run the display multicast routing-table static [ config ] [ source-address { mask-
length | mask } ] command to check the information about the static multicast route.
Run the display multicast rpf-info source-address [ group-address ] command to check
the information about the RPF route.
CAUTION
Run the debugging mfib all or debugging mfib { no-cache | module | packet | register
| route | sync | upcall | wrong-iif } [ advanced-acl-number ] [ slot slot-number ] command
to enable debugging of multicast forwarding.
Run the debugging mrm { all | event | packet [ advanced-acl-number ] | route [ advanced-
acl-number ] } command to enable debugging of multicast routing.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
*
command to check the information about the multicast
Configuration Guide - Multicast
Issue 01 (2009-07-28)