Huawei Quidway S9300 Configuration Manual - Multicast page 76

2 IGMP Configuration
l
l
Procedure
Step 1 Configure the IP addresses of interfaces and the unicast routing protocol on each S9300.
Configure the IP address and mask of each interface according to
to ensure the communication between S9300-A, S9300-B, and S9300-C on the network layer,
and to ensure the dynamic update through the unicast routing protocol.
For how to configure IP addresses of interfaces, see
in the Quidway S9300 Terabit Routing Switch Configuration Guide - Basic Configurations. For
how to configure OSPF, see
Switch Configuration Guide - IP Routing.
Step 2 Enable multicast on all S9300s and PIM-SM on all interfaces.
# Enable multicast on S9300-A and enable PIM-DM on all interfaces. The configurations of
S9300-B and S9300-C are similar to the configuration of S9300-A, and are not mentioned here.
[S9300-A] multicast routing-enable
[S9300-A] interface vlanif 10
[S9300-A-Vlanif10] pim sm
[S9300-A-Vlanif10] quit
[S9300-A] interface vlanif 11
[S9300-A-Vlanif11] pim sm
[S9300-A-Vlanif11] quit
Step 3 Enable IGMP on the interfaces connected to hosts.
# Enable IGMP on VLANIF 10 on S9300-A and configure the IGMP version as IGMPv2. The
configurations of S9300-B and S9300-C are similar to the configuration of S9300-A, and are
not mentioned here.
[S9300-A] interface vlanif 10
[S9300-A-Vlanif10] igmp enable
[S9300-A-Vlanif10] igmp version 2
[S9300-A-Vlanif10] quit
Step 4 Add VLANIF 10 on S9300-A to the multicast group 225.1.1.1 statically. In this manner, the
hosts connected to VLANIF 10 can steadily receive the multicast data sent to the multicast group
225.1.1.1.
[S9300-A] interface vlanif 10
[S9300-A-Vlanif10] igmp static-group 225.1.1.1
Step 5 Verify the configuration.
# Run the display igmp interface command. You can check the configuration and running status
of IGMP on each interface. For example, the information about IGMP on VLANIF 10 of
S9300-A is as follows:
<S9300-A> display igmp interface vlanif 10
Vlanif 10(10.110.1.1):
2-22
Version of IGMP running between S9300s and hosts
Static multicast group address: 225.1.1.1
NOTE
This configuration example describes only the commands used to configure IGMP.
NOTE
By default, IGMPv2 is used and you do not need to set the IGMP version here. To use other IGMP versions,
run the igmp version command to set the version.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OSPF Configuration in theQuidway S9300 Terabit Routing
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Figure 2-1. Configure OSPF
Assigning an IP address to an Interface
Issue 01 (2009-07-28)