Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Step 3 Run:
ssm-policy acl-number
The PIM-SSM address range is configured.
----End

4.15.5 Checking the Configuration

Prerequisite
The configuration of PIM SSM is complete.
Procedure
l
l
----End
Example
Run the display pim interface vlanif 15 verbose command, and you can view the PIM
information on VLANIF 15.
<Quidway> display pim interface vlanif 15 verbose
VPN-Instance: public net
Interface: Vlanif15, 10.0.0.15
Issue 01 (2009-07-28)
Run the display pim interface [ interface-type interface-number | up | down ]
[ verbose ] command to check the PIM information on the interface.
Run the display current-configuration [ configuration [ configuration-type ] |
controller | interface [ interface-type [ interface-number ] ] ] [ | { begin | exclude |
include } regular-expression ] to check the effective parameters on the S9300.
PIM version: 2
PIM mode: Sparse
PIM state: up
PIM DR: 10.0.0.15 (local)
PIM DR Priority (configured): 1
PIM neighbor count: 0
PIM hello interval: 30 s
PIM LAN delay (negotiated): 1800 ms
PIM LAN delay (configured): 1800 ms
PIM hello override interval (negotiated): 60000 ms
PIM hello override interval (configured): 60000 ms
PIM Silent: disabled
PIM neighbor tracking (negotiated): enabled
PIM neighbor tracking (configured): enabled
PIM generation ID: 0XE5F4034D
PIM require-GenID: disabled
PIM hello hold interval: 36000 s
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 PIM-SM Configuration
4-51