Configuring Ssm Mapping; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual - Multicast

2 IGMP Configuration
----End
Example
Run the display igmp group interface vlanif 3 static command, and you can view the IGMP
configuration on VLANIF 3.
<Quidway> display igmp group interface vlanif 3 static
Static join group information of VPN-Instance: public net
Total 2 entries
Total 2 entries matched
Group Address
225.0.0.1
225.0.0.10
Run the display igmp routing-table command, and you can view the IGMP routing table.
<Quidway> display igmp routing-table
Routing table of VPN-Instance: public net
Total 1 entry
00001. (*, 225.0.0.10)

2.6 Configuring SSM Mapping

This section describes the applications of SSM mapping and the method of configuring SSM
mapping.

2.6.1 Establishing the Configuration Task

2.6.2 Enabling SSM Mapping
2.6.3 Configuring the SSM Mapping Policy
2.6.4 Checking the Configuration
2.6.1 Establishing the Configuration Task
Applicable Environment
In the network segment where the SSM model is used to provide multicast services, some hosts
must run IGMPv1 or IGMPv2 because of some limitations. To provide services for these hosts,
you need to configure the SSM static mapping on S9300s.
2-16
The membership information of the IGMP multicast group is correct.
–
The configuration and running status of IGMP on an S9300 interface are correct.
–
A matched multicast forwarding interface exists in the downstream list of the (*, G) or
–
(S, G) entry.
Source Address
10.0.0.1
0.0.0.0
NOTE
The IGMP routing table is generated only after PIM is enabled.
List of 1 downstream interface
Vlanif3 (100.0.0.3),
Protocol: STATIC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Expires
never
never
Configuration Guide - Multicast
Issue 01 (2009-07-28)