Setting The Pim Neighbor Control Parameters - Huawei Quidway S9300 Configuration Manual - Multicast

3 PIM-DM Configuration
Applicable Environment
S9300s that run PIM establish the neighbor relation by exchanging Hello messages to negotiate
various control parameters.
S9300s configured with default values can work normally. You can change the values of relevant
parameters according to the specific network environment. If there is no special requirement,
default values are recommended.
Pre-configuration Tasks
Before changing the values of parameters for maintaining neighbors, complete the following
tasks:
l
l
Data Preparation
To change the values of parameters for maintaining neighbors, you need the following data.
No.
1
2
3

3.6.2 Setting the PIM Neighbor Control Parameters

Context
The PIM neighbor control parameters can be set globally or on an interface.
l
l
Procedure
l
3-10
Configuring the unicast routing protocol to ensure that IP routes between nodes are
reachable
3.4 Configuring Basic PIM-DM Functions
The global configuration is valid for each interface.
The configuration on an interface is valid only for the specified interface. The configuration
on an interface takes precedence over the global configuration. If the parameters for
maintaining PIM neighbors are not set on the interface, the global configuration is used.
Setting the PIM neighbor control parameters globally
1. Run:
system-view
The system view is displayed.
2. Run:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Data
Timeout interval of the Hello messages from
neighbors
Interval for sending Hello messages
Maximum delay for triggering Hello
messages
Issue 01 (2009-07-28)