Huawei Quidway S9300 Configuration Manual - Multicast page 219

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure the IP addresses of interfaces and the unicast routing protocol.
# According to
Configure the OSPF protocol between S9300s. Ensure the communication on the network layer
within an AS. Ensure the dynamic route update between S9300s through unicast routing
protocol. The configuration procedure is not mentioned.
Step 2 Configure EBGP peer relation between ASs and import routes of BGP and OSPF into each
other's routing table.
# Configure EBGP on S9300-B and import OSPF routes.
[S9300-B] bgp 100
[S9300-B-bgp] router-id 1.1.1.1
[S9300-B-bgp] peer 192.168.2.2 as-number 200
[S9300-B-bgp] import-route ospf 1
[S9300-B-bgp] quit
# Configure EBGP on S9300-C and import OSPF routes.
[S9300-C] bgp 200
[S9300-C-bgp] router-id 2.2.2.2
[S9300-C-bgp] peer 192.168.2.1 as-number 100
[S9300-C-bgp] import-route ospf 1
[S9300-C-bgp] quit
# Import BGP routes to OSPF on S9300-B. The configuration on S9300-C is similar to the
configuration on S9300-B, and is not mentioned here.
[S9300-B] ospf 1
[S9300-B-ospf-1] import-route bgp
[S9300-B-ospf-1] quit
Step 3 Enable multicast, enable PIM-SM on all interfaces, configure the domain boundary, and enable
IGMP on the interface connecting to the host.
Issue 01 (2009-07-28)
Enable multicast and PIM-SM on each interface, configure the boundary domain, and
enable the IGMP function on the interfaces connected to hosts.
Configure the C-BSR and C-RP. Configure the RPs of PIM-SM1 and PIM-SM2 on the
ASBR.
Establish MSDP peer relation between RPs of each doman. The MSDP peers and the EBGP
peers between ASs use the same interface addresses. According to the RPF rule, the S9300s
receive SA messages from the next hop toward the source RP.
Address of multicast group G: 225.1.1.1/24
Number of the AS that S9300-A and S9300-B belong to, namely 100, and router ID of
S9300-B, namely, 1.1.1.1
Number of the AS that S9300-C and S9300-D belong to, namely 200, and Router ID of
S9300-C, namely, 2.2.2.2
Number of the AS that S9300-E and S9300-F belong to, namely 200
NOTE
This configuration example describes only the commands related to MSDP configuration.
Figure 5-1, configure IP addresses and masks for the interfaces on each S9300.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 MSDP Configuration
5-27