Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Multicast

5 MSDP Configuration
Context
l
l
Do as follows on the S9300 where an MSDP peer is configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
msdp
The MSDP view is displayed.
Step 3 Run:
import-source [ acl acl-number ]
The rule for filtering sources in SA messages is configured.
l
l
Step 4 Run:
peer peer-address sa-policy { import | export } [ acl acl-number ]
The rule for filtering received and to-be-forwarded SA messages is configured.
By default, the S9300 accepts and forwards all SA messages that pass the RPF check.
----End

5.7.6 Checking the Configuration

Prerequisite
The configuration related to the SA message is complete.
Procedure
l
l
5-22
After the rule for filtering sources in SA messages is configured on the source RP, the
source RP filters the active sources registered locally according to the rule. That is, the
source RP determines the (S, G) information to be advertised according to the rule.
After the rule for filtering received and to-be-forwarded SA messages from the remote
MSDP peer is configured, the S9300 determines whether to accept or forward SA messages
when the SA messages sent by the remote MSDP peer reach the S9300.
By default, the SA message created by the source RP contains the information about all the
active local sources.
If you run the import-source command without acl, the SA message does not advertise any
information about any local active source.
Run the display msdp brief command to check the brief information about the status of
the MSDP peer.
Run the display msdp peer-status command to check the detailed information about the
MSDP peer.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Issue 01 (2009-07-28)