Figure 6-1 Networking Diagram For Changing Static Multicast Routes To Rpf Routes - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
6.9.1 Example for Changing Static Multicast Routes to RPF Routes
6.9.2 Example for Connecting RPF Routes Through Static Multicast Routes
6.9.1 Example for Changing Static Multicast Routes to RPF Routes
Networking Requirements
As shown in
The receiver can receive information from the multicast source. S9300-A, S9300-B, and S9300-
C run OSPF. You need to configure a static multicast route to make the multicast path from the
source to the receiver different from the unicast path from the source to the receiver.

Figure 6-1 Networking diagram for changing static multicast routes to RPF routes

Switch
S9300-A
S9300-B
S9300-C
Configuration Roadmap
The configuration roadmap is as follows:
Issue 01 (2009-07-28)
Figure 6-1, PIM-DM runs on the network and all the S9300s support multicast.
GE3/0/0
GE3/0/0
S9300-A
GE1/0/0
GE2/0/0
8.1.1.2/24
Source
Multicast static route
Physical interface
GE 1/0/0
GE 2/0/0
GE 3/0/0
GE 1/0/0
GE 2/0/0
GE 3/0/0
GE 2/0/0
GE 3/0/0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
S9300-C
GE2/0/0
PIM-DM
GE2/0/0
GE1/0/0
GE3/0/0
7.1.1.2/24
Receiver
VLANIF interface
VLANIF 10
VLANIF 20
VLANIF 30
VLANIF 10
VLANIF 40
VLANIF 50
VLANIF 40
VLANIF 30
6 Multicast Route Management
S9300-B
IP address
9.1.1.1/24
8.1.1.1/24
12.1.1.1/24
9.1.1.2/24
13.1.1.1/24
7.1.1.1/24
13.1.1.2/24
12.1.1.2/24
6-17