Maintaining Pim-Sm; Clearing The Statistics On Pim Control Messages; Monitoring The Running Status Of Pim-Sm - Huawei Quidway S9300 Configuration Manual - Multicast

4 PIM-SM Configuration

4.16 Maintaining PIM-SM

This section describes how to clear the statistics on PIM-SM, how to debug PIM-SM, and how
to monitor the running status of PIM-SM.

4.16.1 Clearing the Statistics on PIM Control Messages

4.16.2 Monitoring the Running Status of PIM-SM

4.16.3 Debugging PIM-SM
4.16.1 Clearing the Statistics on PIM Control Messages
Context
Statistics on PIM control messages on an interface cannot be restored after you clear them. So,
confirm the action before you run the command.
Procedure
l
----End
4.16.2 Monitoring the Running Status of PIM-SM
Context
During routine maintenance, you can run the following commands in any view to understand
the running status of PIM-SM.
Procedure
l
4-52
PIM assert hold interval: 360 s
PIM triggered hello delay: 5 s
PIM J/P interval: 60 s
PIM J/P hold interval: 210 s
PIM state-refresh capability on link: non-capable
PIM BSR domain border: enabled
PIM BFD: disabled
PIM dr-switch-delay timer : not configured
Number of routers on link not using DR priority: 0
Number of routers on link not using LAN delay: 0
Number of routers on link not using neighbor tracking: 0
CAUTION
Run the reset pim control-message counters [ interface interface-type interface-
number in the user view to clear statistics on PIM control messages on an interface.
Run the display pim claimed-route [ source-address ] command to check the unicast
routing information that PIM uses.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Issue 01 (2009-07-28)