Configuring The Ssm Mapping Policy; Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Multicast

2 IGMP Configuration

2.6.3 Configuring the SSM Mapping Policy

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
igmp
The IGMP view is displayed.
Step 3 Run:
ssm-mapping group-address { mask | mask-length } source-address
An SSM group is mapped to a source.
The IP addresses of SSM groups range from 232.0.0.0 to 232.255.255.255. You can run the
command repeatedly to map an SSM group to multiple sources.
l
l
----End

2.6.4 Checking the Configuration

Prerequisite
The configuration of SSM mapping is complete.
Procedure
l
l
----End
Example
Run the display igmp ssm-mapping group [ group-address ] command, and you can view the
information about SSM mapping of a specified group address.
<Quidway> display igmp ssm-mapping group 232.0.0.1
IGMP SSM-Mapping conversion table of VPN-Instance: public net
Total 3 entries
00001. (10.0.0.1, 232.0.0.1)
00002. (10.0.0.2, 232.0.0.1)
2-18
group-address { mask | mask-length }: specifies the group address and mask.
source-address: specifies the address of the source mapping the SSM group.
Run the display igmp group [ group-address | interface interface-type interface-
*
number ] ssm-mapping [ verbose ] command to check the address of a specific source or
group.
Run the display igmp ssm-mapping { group [ group-address ] | interface [ interface-type
interface-number ] } command to check the information about SSM mapping of a specific
source or group.
2 entries matched
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Issue 01 (2009-07-28)