Enabling Ssm Mapping - Huawei Quidway S9300 Configuration Manual - Multicast

Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Pre-configuration Tasks
Before configuring SSM mapping, complete the following tasks:
l
l
Data Preparation
To configure SSM mapping, you need the following data.
No.
1
2

2.6.2 Enabling SSM Mapping

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The S9300 communicates with hosts through this interface. On the S9300, VLANIF interfaces
and loopback interfaces support IGMP.
Step 3 Run:
igmp enable
The IGMP function is enabled.
Step 4 Run:
igmp version 3
The version number of IGMP is set to 3.
To ensure that hosts running any IGMP version on the network segment can obtain SSM services,
it is recommended to run IGMPv3 on the S9300 interface.
Step 5 Run:
igmp ssm-mapping enable
SSM mapping is enabled.
----End
Issue 01 (2009-07-28)
Configuring the unicast routing protocol to ensure that the IP routes between nodes are
reachable
2.4.3 Enabling the IGMP Function
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Data
Interface that needs to be enabled with SSM
mapping
Addresses and masks of the multicast group
and multicast source
2 IGMP Configuration
2-17