Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
No.
5
6
7
8
1.6.2 Enabling IGMP Snooping
Context
By default, IGMP snooping is disabled on the S9300. You need to enable IGMP snooping on
the S9300 globally. After IGMP snooping is enabled globally, IGMP snooping remains disabled
in a VLAN, by default. Therefore, you need to enable IGMP snooping in a VLAN.
Do as follows on the S9300 that receives multicast packets from a router and forwards the
multicast packets to hosts.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
igmp-snooping enable
IGMP snooping is enabled globally.
Step 3 Run:
vlan vlan-id
The VLAN view is displayed.
Step 4 Run:
igmp-snooping enable
IGMP snooping is enabled in the VLAN.
----End
1.6.3 (Optional) Setting the IGMP Version
Issue 01 (2009-07-28)
NOTE
To enable IGMP snooping for multiple VLANs, repeat steps 3 to 4 as required.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Layer 2 Multicast Configuration
Data
(Optional) ACL rules applied to a multicast
policy
Suppression duration of IGMP messages
Aging time of the router interface
Source IP address of IGMP Query messages
1-13