Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Multicast

6 Multicast Route Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip rpf-route-static source-address { mask | mask-length } [ protocol [ process-
id ] ] [ route-policy policy-name ] rpf-address [ preference preference ] [ order
order-num ]
The static multicast route is configured.
l
l
l
l
l
l
----End

6.4.3 Checking the Configuration

Prerequisite
The configuration of a static multicast route is complete.
Procedure
l
l
----End
Example
After configuring a static multicast route, run the display multicast routing-table static
command. You can view information about the multicast static route.
<Quidway> display multicast routing-table static
Multicast Routing Table
Routes : 1
Mroute 11.1.0.0/24
Running Configuration = ip rpf-route-static 11.1.0.0 24 ospf 100 11.1.2.2 order 1
6-6
source-address { mask | mask-length }: specifies the address and mask of the multicast source.
protocol [ process-id ]: indicates that the matched route must be contained in the specified
unicast routing protocol.protocol specifies the unicast routing protocol. process-id specifies
the process number.
route-policy policy-name: specifies the matching rule of the static multicast route.
rpf-address: specifies the IP address of the RPF interface.
preference preference: specifies the route preference. A greater value of preference indicates
a higher preference.
order order-num: specifies the sequence of configurations of routes on the same segment.
Run the display multicast routing-table static [ config ] [ source-address { mask | mask-
length } ] command to check the information about the static multicast routing table.
Run the display multicast rpf-info source-address [ group-address ] command to check
the information about RPF routes with the specified multicast source.
Interafce = Vlanif100
Matched routing protocol = ospf, process-id = 100, Route-policy = none
Preference = 1, Order = 1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
RPF Neighbor = 11.1.2.2
Issue 01 (2009-07-28)