Configuring Ssm Mapping; Establishing The Configuration Task - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
<Quidway> display igmp group interface vlanif 3 static
Static join group information
Total 2 entries
Specified interface state:UP
Total 2 entries matched
Group Address
232.1.1.1
225.0.0.10
Run the display igmp routing-table command, and you can view the IGMP routing table.
<Quidway> display igmp routing-table
Total 1 entry
00001. (*, 225.0.0.10)

4.5 Configuring SSM Mapping

This section describes the applications of SSM mapping and the method of configuring SSM
mapping.

4.5.1 Establishing the Configuration Task

Applicable Environment
In the network segment where the SSM model is used to provide multicast services, some hosts
must run IGMPv1 or IGMPv2 because of some limitations. To provide services for these hosts,
you need to configure the SSM static mapping on S7700s.
Pre-configuration Tasks
Before configuring SSM mapping, complete the following tasks:
l
l
Data Preparation
To configure SSM mapping, you need the following data.
No.
1
2
Issue 01 (2011-07-15)
Source Address
10.0.0.1
0.0.0.0
NOTE
The IGMP routing table is generated only after PIM is enabled.
List of 1 downstream interface
Vlanif3 (100.0.0.3),
Protocol: STATIC
Configuring the unicast routing protocol to ensure that the IP routes between nodes are
reachable
4.3.3 Enabling the IGMP Function
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Expires
never
never
Data
Interface that needs to be enabled with SSM
mapping
Addresses and masks of the multicast group
and multicast source
4 IGMP Configuration
83