Adjusting C-Rp Parameters - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
Applicable Environment
This section describes how to adjust control parameters of the C-RP and the C-BSR by using
commands in the ASM model.
The switch can work properly by using default values of control parameters. The S7700 allows
users to adjust parameters.
Pre-configuration Tasks
Before adjusting control parameters of the C-RP and C-BSR, complete the following tasks:
l
l
Data Preparation
To adjust various control parameters of the C-RP and C-BSR, you need the following data.
No.
1
2
3
4
5
6
7
8

6.5.2 Adjusting C-RP Parameters

C-RPs periodically send Advertisement messages to a BSR. The Advertisement messages carry
C-RP priorities. You can adjust the C-RP priority, the interval for sending Advertisement
messages, and the holdtime of Advertisement messages on a device configured with the C-RP.
Context
Do as follows on the switch configured with the C-RP:
Issue 01 (2011-07-15)
NOTE
The configuration is applicable only to a BSR-RP. If you want to use only a static RP in the network, skip
the configuration.
NOTE
Default values are recommended.
Configuring a unicast routing protocol
Configuring Basic PIM-SM Functions
Data
C-RP priority
Interval for a C-RP to send Advertisement messages
Timeout of the period during which a BSR waits to receive Advertisement messages
from a C-RP
Hash mask length of a C-BSR
Priority of a C-BSR
Interval for a C-BSR to send Bootstrap messages
Time of holding the Bootstrap message received from a BSR
ACL defining the valid BSR address scope
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PIM-SM (IPv4) Configuration
158