Cisco MDS 9000 series Command Reference Manual page 1425

Chapter 25 V Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Before you configure Interop mode 4 (or remove the configuration), you must suspend the VSAN. You
Note
should unsuspend the VSAN only after you configure a VSAN-dependent switch WWN with the
McData OUI [08:00:88].
Examples The following examples show how to create multiple fabrics sharing the same physical infrastructure and
how to assign ports to VSANs.
switch# config terminal
switch(config)# vsan database
switch(config-db)#
switch-config-db# vsan 2
switch(config-vsan-db)# vsan 2 name TechDoc
updated vsan 2
switch(config-vsan-db)# vsan 2 loadbalancing src-dst-id
switch(config-vsan-db)# vsan 2 loadbalancing src-dst-ox-id
switch(config-vsan-db)# vsan 2 suspend
switch(config-vsan-db)# no vsan 2 suspend
switch(config-vsan-db)# vsan 2 interface fv2/8/2
switch(config-vsan-db)# vsan 2 interface iscsi 2/1
switch(config-vsan-db)# end
switch#
The following example shows how to suspend a VSAN and enable interop mode 4.
switch# config t
switch(config)# vsan database
switch(config-vsan-db)# vsan 100 suspend
switch(config-vsan-db)# vsan 100 interop 4
switch(config-vsan-db)# exit
Related Commands Command
vsan wwn
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Description
Configures a WWN for a suspended VSAN that has interop mode 4 enabled.
Cisco MDS 9000 Family Command Reference
vsan database
25-11