Configuring Interface Modes; Configuring System Default Port Mode F - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 13 Configuring Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring Interface Modes

To configure the interface mode, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# interface fc1/1
switch(config-if)#
Step 3
switch(config-if)# switchport mode F
switch(config-if)#
switch(config-if)# switchport mode auto
switch(config-if)#

Configuring System Default Port Mode F

The system default switchport mode F command sets the administrative mode of all Fibre Channel
ports to mode F, while avoiding traffic disruption caused by the formation of unwanted inter-switch links
(ISLs). This command is part of the setup utility that runs during bootup after a write erase or reload.
It can also be executed from the command line in configuration mode. This command changes the
configuration of the following ports to administrative mode F:
•
•
This command does not affect the configuration of the following ports:
•
•
Example 13-1
command line.
Example 13-1 Setup Utility
Configure default switchport mode F (yes/no) [n]: y
Example 13-2 Command Line
switch(config)# system default switchport mode F
OL-18084-01, Cisco MDS NX-OS Release 4.x
All ports that are down and that are not out-of-service.
All F ports that are up, whose operational mode is F, and whose administrative mode is not F.
All user-configured ports, even if they are down.
All non-F ports that are up; however, if non-F ports are down, this command changes the
administrative mode of those ports.
shows the command in the setup utility, and
Purpose
Enters configuration mode.
Selects a Fibre Channel interface and enters interface
configuration submode.
Configures the administrative mode of the port. You
can set the operational state to auto, E, F, FL, Fx, TL,
NP, or SD port mode.
Note Fx ports refers to an F port or an FL port (host
connection only), but not E ports.
Configures the interface mode to auto-negotiate an E,
F, FL, or TE port mode (not TL or SD port modes) of
operation.
Note TL ports and SD ports cannot be configured
automatically. They must be administratively
configured.
You cannot configure Fibre Channel interfaces
Note
on SSMs in auto mode.
Example 13-2
Cisco MDS 9000 Family CLI Configuration Guide
Fibre Channel Interfaces
shows the command from the
13-13