Zone Broadcast Enable Vsan - Cisco MDS 9000 series Command Reference Manual

zone broadcast enable vsan

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
zone broadcast enable vsan
To enable zone broadcast frames for a VSAN in basic zoning mode, use the zone broadcast enable
command in configuration mode. To disable this feature, use the no form of the command.
Syntax Description
vsan-id
Defaults None.
Command Modes Configuration mode.
Command History Release
2.0(x)
Usage Guidelines Broadcast frames are sent to all Nx Ports. If any NL port attached to an FL port shares a broadcast zone
with the source of the broadcast frame, then the frames are broadcast to all devices in the loop.
This command only applies to basic zoning mode.
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
Note
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example shows how to enable zone configuration broadcasting over the fabric.
switch# config terminal
switch(config)# zone broadcast enable vsan 10
Related Commands Command
show zone
Cisco MDS 9000 Family Command Reference
27-2
zone broadcast enable vsan vsan-id
no zone broadcast enable vsan vsan-id
Specifies the VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays zone information.
Chapter 27 Z Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x