Tcp Qos Control - Cisco MDS 9000 series Command Reference Manual

Chapter 23 T Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

tcp qos control

To specify the differentiated services code point (DSCP) value to mark all IP packets (type of
service—TOS field in the IP header), use the tcp qos control command. Use the no form of this
command to disable this feature or revert to its factory defaults.
Syntax Description value
data value
Defaults Enabled.
Command Modes FCIP profile configuration submode.
Command History Release
1.1(1)
Usage Guidelines Use these TCP parameters to control TCP retransmission behavior in a switch.
Examples The following example configures a FCIP profile:
switch# config terminal
switch(config)# fcip profile 5
switch(config-profile)#
The following example configures the control TCP connection and data connection to mark all packets
on that DSCP value:
switch(config-profile)# tcp qos control 3 data 5
Related Commands Command
fcip profile
show fcip profile
OL-8413-07, Cisco MDS SAN-OS Release 3.x
tcp qos control value data value
no tcp qos control value data value
Modification
This command was introduced.
Description
Configures FCIP profile parameters.
Displays FCIP profile information.
Applies the control DSCP value to all FCIP frames in the control TCP
connection.
Applies the data DSCP value applies to all FCIP frames in the data
connection.
Cisco MDS 9000 Family Command Reference
tcp qos control
23-35