Cleaning The Ink Head And The Area Around It - MIMAKI JV150-130 Operation Manual

Cleaning the Ink Head
and the Area around It
Because the ink head
mechanism, due care needs to be taken when it is
cleaned.
Using a clean stick, etc., rub off gelatinous ink or dust that
may stick to the lower part of the slider and the area
around the ink head.In doing so, never rub the nozzles of
the head.
Tools required for cleaning
• Clean stick (SPC-0527)
• Goggles
• Be sure to wear the attached goggles and gloves
when cleaning the area around the ink
head.Otherwise, you may get ink in your eyes.
• The ink contains organic solvent.If you get the ink
on your skin or in your eyes, wash it away with
plenty of water immediately.
1
Press the
key in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press the
• "CARRIAGE OUT" will be selected.
3
Press , and press the
• "HEAD MAINTENANCE" will be selected and the
carriage will move to the left end of this machine.
4
Open the maintenance cover.
employs a very precise
• Gloves
(MENU)
key twice.
key.
5
Use a clean stick soaked in maintenance
cleaning fluid to wipe ink off the head
surface or other surfaces.
• Never rub the nozzles.
Clean the side surface of the head
(shown in deep gray) with a clean stick.
The nozzle part (Never
touch it.)
Clean with a clean stick or a waste cloth.
6
Press the
7
Close the maintenance cover, and press
the key.
• After its initial operation, the machine returns to
LOCAL.
Chapter 4 Maintenance
key after the cleaning.
4-11
1
2
2
4
5
6