Interface Selection; Table 1-4 Configuration Menus - Keithley 2601 Reference Manual

Section 1: Getting Started
Menu selection
LINE-FREQ
AUTO
50Hz
60Hz
SYSTEM-INFO
FIRMWARE
SERIAL#
CAL
Configuration menus
The configuration menus are summarized in
selection. There are two ways to make selections:
• Press CONFIG, then navigate to the desired submenu.
• Press CONFIG, then press the associated key. For example, pressing CONFIG followed by
REL takes you directly to the Relative menu.
Menu selections
CHANNEL-A
SRC
MEAS
LIMIT
SPEED
REL
FILT
OUTPUT
CHANNEL-B
SRC
MEAS
LIMIT
SPEED
REL
FILT
OUTPUT
COMMON
TRIG
STORE

Interface selection

The following summarizes basic interface selection for the Series 2600. Details on the interfaces,
including configuration, are provided in
described earlier in this section to select and configure the interface.
1-20
Description
Configure the line frequency.
Automatically selects the line frequency.
Displays the system information.
Displays the version of firmware installed.
Displays the serial number of the unit.
Displays the last calibration date.
Table 1-4
Configuration menus
Shortcut Description
Configure Channel A:
SRC V-source sense, low range; I-source low range.
MEAS V and I-Measure sense, low range; auto zero.
LIMIT V-source and I-source compliance limits.
SPEED Measurement speed (NPLC).
REL Set relative values.
FILTER Control digital filter.
OUTPUT Set off-state, control digital I/O.
Configure Channel B:
SRC V-source sense, low range; I-source low range.
MEAS V and I-Measure sense, low range; auto zero.
LIMIT V-source and I-source compliance limits.
SPEED Measurement speed (NPLC).
REL Set relative values.
FILTER Control digital filter.
OUTPUT Set off-state, control digital I/O.
Configure common functions:
TRIG Set trigger in, count, interval, and delay.
STORE Set buffer count and destination.
Return to
Series 2600 System SourceMeter® Instruments Reference Manual
Table 1-4, along with the reference for each main
Section 11. Use the editing controls for
Section Topics
Reference
Section 1
Section 1
Reference
Section 4
Section 4
Section 4
Section 6
Section 6
Section 6
Section 3
Section 10
Section 4
Section 4
Section 4
Section 6
Section 6
Section 6
Section 3
Section 10
Section 9
Section 7
"Menu navigation"
2600S-901-01 Rev. C / January 2008