Keithley 2601 Reference Manual page 401

Series 2600 System SourceMeter® Instruments Reference Manual
Table 13-14 (continued)
KIGeneral TSP test script: ConfigPulseIMeasureVSweepLog
TSP project name:
TSP test script name:
Firmware version:
Function:
ConfigPulseIMeasureVSweepLog
Usage:
f, msg = ConfigPulseIMeasureVSweepLog
(smu,bias,start,stop,limit,ton,toff,points,buffer,tag[,sync_in]
[,sync_out][,sync_in_timeout][,sync_in_abort])
Waveform
Return
Values
Output
Data
Example
See Also
2600S-901-01 Rev. C / January 2008
KIFactoryPulse
KIPulse
1.2.0 and later
A Boolean flag. This flag will be true when the pulse was successfully
f:
configured, false when errors were encountered.
A string message. If the f flag is false, msg will contain an error
msg:
message. Otherwise, msg will contain a string indicating successful
configuration.
Pulsed voltage measurements are stored in the reading buffer specified by the
buffer input argument.
ConfigPulseIMeasureVSweepLog(smua, 0, 1e-3, 0.01, 1, 1e-3,
10e-3, 10, smua.nvbuffer1, 5)
Set up a pulsed log sweep that will use SourceMeter Channel A. The pulsed
sweep will start at 1mA, end at 10mA, and return to a 0A bias level between
pulses. Each pulsed step will be on for 1msec and then at the bias level for
10msec. The voltage limit will be 1V during the entire pulsed sweep. The pulse
train will be comprised of 10 pulsed steps and the pulse train will be assigned a
tag index of 5.
InitiatePulseTest, InitiatePulseTestDual
Return to Section Topics
Section 13: Factory Scripts
13-23