Using Test Script Builder - Keithley 2601 Reference Manual

Series 2600 System SourceMeter® Instruments Reference Manual
• Baud rate: 9600
• Data bits: 8
• Parity: None
• Flow Control: None
The RS-232 settings can be changed from the communications menu. To access the menu, press
the MENU key, select COMMUNICATIONS, and then select RS-232.
The RS-232 settings are stored in non-volatile memory. The settings will not change when power
is cycled or a reset command (

Using Test Script Builder

Test Script Builder is a supplied software tool that can be used to perform the following operations:
• Send ICL commands and TSL statements
• Receive responses (data) to commands and scripts
• Run factory scripts
• Create and run user scripts
Figure 2-5
three window panes:
Project Navigator
The window pane on the left side of the Workspace is where the Project Navigator resides. The
navigator consists of created project folders and the script files (.tsp) created for each project.
Each project folder can have one or more script files.
The navigator shown in
"SourceMeasure." As shown, the "BeeperTest" project has one script file, and the
"SourceMeasure" project has three script files.
Script Editor
The script chunk is written and/or modified in the Script Editor. Notice that there is a tab available
for each opened script file. A script project is then downloaded to the SourceMeter where it can be
run.
Programming Interaction
Up to seven tabs can be displayed in the lower window pane of the Workspace to provide
programming interaction between the Test Script Builder and the SourceMeter. The Instrument
Console (shown open in
Retrieved data (e.g., readings) from commands and scripts appear in the Instrument Console. See
"Programming interaction
2600S-901-01 Rev. C / January 2008
reset
shows an example of the Test Script Builder. As shown, the Workspace is divided into
Figure 2-5
Figure 2-5) is used to send commands to the connected SourceMeter.
tabs" later in Section 2 for details on using the other tabs.
Return to Section Topics
or *RST) is sent.
has two projects; one named "BeeperTest" and one named
Section 2: TSP Programming
2-11