Keithley 2601 Reference Manual page 489

Keithley Instruments, Inc.
28775 Aurora Road
Cleveland, Ohio 44139
1-888-KEITHLEY
www.keithley.com
Specifications Category
Overshoot
ADDITIONAL SOURCE SPECIFICATIONS
Specifications Category
Transient Response
Time
Voltage Source Output
Settling Time
Current Source Output
Settling Time
DC Floating Voltage
Remote Sense
Operating Range
Voltage Output
Headroom
6
Add 50 µV to source accuracy specifications per volt of HI lead drop.
Specifications are subject to change without notice.
SPEC-2636_2636 Rev. A / September 2007
Specifications
< ± 0.1% (typical)
• step size = 10% to 90% of range, resistive load, maximum -
current limit/compliance
• See CURRENT SOURCE OUTPUT SETTLING TIME for
additional test conditions
Specifications
< 70 µs for the output to recover to 0.1% for a 10% to 90% step
change in load.
Time required to reach 0.1% of final value after source level
command is processed on a fixed range.
200 mV
Time required to reach 0.1% of final value after source level
command is processed on a fixed range.
• Values below for Iout × Rload = 2 V unless noted
Current Range
1.5 A – 1 A
100 mA – 10 mA
Output can be floated up to ± 250 VDC
Maximum voltage between HI and SENSE HI = 3 V
6
Maximum voltage between LO and SENSE LO = 3V
200 V Range
• Maximum output voltage = 202.3 V – total voltage drop across
source leads. (maximum 1
20 V Range
• Maximum output voltage = 23.3 V – total voltage drop across
source leads. (maximum 1
System SourceMeter
Range
2 V
20 V
200 V
1 mA
100 µA
10 µA
1 µA
100 nA
10 nA
1 nA
Model 2635/2636
®
Specifications
Settling Time
< 50 µs (typical)
< 50 µs (typical)
< 110 µs (typical)
< 700 µs (typical)
Settling Time
< 120 µs (typical) (Rload > 6 )
< 80 µs (typical)
< 100 µs (typical)
< 150 µs (typical)
< 500 µs (typical)
< 2 ms (typical)
< 20 ms (typical)
< 40 ms (typical)
< 150 ms (typical)
per source lead)
per source lead)
Page 3 of 8