Keithley 2601 Reference Manual page 437

Series 2600 System SourceMeter® Instruments Reference Manual
Figure 15-1
Connections for voltage verification
2. Select the multimeter DC volts measuring function.
3. Select the Model 2602/2612/2636 single-channel display mode. Press the Series 2600 SRC
key to source voltage, and make sure the source output is turned on.
4. Enable the Series 2600 4-wire (remote sense) mode by pressing CONFIG then SRC, then
select V-SOURCE > SENSE-MODE > 4-WIRE.
5. Verify output voltage accuracy for each of the voltages listed in
2602) or
•
2600S-901-01 Rev. C / January 2008
WARNING:
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
GUARD
SENSE
SENSE HI LO
CHANNEL B
HI LO
DIGITAL I/O
SENSE
HI
IEEE-488
CAUTION: CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING. FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
Model 2636 channel A
Table 15-3 (Model 2611/2612/2635/2636). For each test point:
Select the correct source range.
Return to
Digital Multimeter
S LO
LO
HI
SENSE CHANNEL A
LO LO HI
GUARD
LINE FUSE
SLOWBLOW
3.15A, 250V
RS-232
GUARD
HI SENSE LO
CHANNEL B
LO
B LO A LO
R
TSP-Link
MADE IN
U.S.A.
connections shown
Section Topics
Section 15: Performance Verification
Input HI
Input LO
S HI
SENSE
HI
!
LINE RATING
100-240VAC
50, 60Hz
240VA MAX.
Table 15-2 (Model 2601/
15-7