Script Launch Configuration - Keithley 2601 Reference Manual

Series 2600 System SourceMeter® Instruments Reference Manual
Figure 2-11
Renaming a project folder and/or script file

Script launch configuration

A script is to be loaded into the Series 2600 where it will be executed (run). The launch
configuration options include the following:
• Select which script files will be included in the launch.
• Set the launch order for the selected script files.
• Set the script launch to load-only, or to load-and-execute (run).
• Set script storage for the Series 2600: volatile or non-volatile. A script stored in volatile
memory will be lost when the SourceMeter power is turned off. A script stored in non-volatile
memory will not be lost after power is turned off.
When a script project is created, the launch is configured initially as follows:
• Only the first script file ("main") is selected to be included in the launch.
• The launch type is set to load-and-execute (run).
• The script project is set to be stored in the volatile memory of the Series 2600. The script
will be lost when the Series 2600 power is turned off.
NOTE If the initial launch configuration meets your requirements, the script
The flowchart in
script. The labels (A through G) are used to identify reference links which follow the illustration.
Figure 2-12
Changing a launch configuration
2600S-901-01 Rev. C / January 2008
is ready to be launched and is explained in
in this section.
Figure 2-12 shows the basic process to change the launch configuration for a
Return to Section Topics
Section 2: TSP Programming
"Launching a script" later
2-19