Section 1: Getting Started
•
•
Via remote, use the beeper.enable command to control the beeper. For
example, the following enables the beeper:
beeper.enable = 1
Display modes
Use the DISPLAY key to cycle through the various display modes shown in
Figure
1-4.
(Models 2602, 2612, and 2636 only) Press the Display key more than once to cycle through the
dual channel and single channel display modes. This applies to CHANNEL A (SMU A) and
CHANNEL B (SMU B).
The Models 2601, 2611, and 2635 are a single channel (SMU A). The User State display
messages are defined with specific display commands (refer to
display messaging).
Figure 1-4
Display modes
1-16
ENABLE
DISABLE
Return to
Series 2600 System SourceMeter® Instruments Reference Manual
Section Topics
Section 14
for more information on
2600S-901-01 Rev. C / January 2008